Tag: Shielding

Shielded Filter Casks

NPO worked closely with AVANTech in designing a set of three shielded casks that reduced dose from 26,000-30,000 mRem/hr (260,000-300,000 μSv/hr) to less than 60 mRem/hr (600 μSv/hr) on contact. Two casks were utilized with one as a spare. Each shielded cask housed one of their Solids Collection Filter canisters for torus water/sludge filtration at […]

Boiler Plate Shields

Inside the steam generators of CANDU nuclear power plants, a divider plate separates the hot leg from the cold leg. Dozens of bolts hold this divider plate together, and these bolts trap hot particles that are a major source of radiation during inspections. NPO designed magnetic shielding designed to fit around each bolt. Since it […]

Mobile Shielded B25 Container

This mobile shielded container has all the same internal dimensions as a standard B25 container, but with a few added features. All six sides of the container are 0.5″ (13 mm) thick steel, which provides dose reduction for the rad waste it is intended to store. There are two sliding doors on top and four […]

Vertical Storage Cask Gap Shielding

“Discrete exposure savings listed at 41 mrem [410 μSv]. However, the shielding also provided critical radiological configuration control during this high profile first time evolution.” -Timothy Bigler, Point Beach Nuclear Point Beach was set to perform a Vertical Storage Cask inspection and required shielding for the VCC/MSB gap created when the shield ring was removed. […]

RadVision3D – LaSalle Case Study

In the scope of one job, LaSalle Generating Station saved 12 Rem (120 mSv) through the use of 3D gamma radiation source mapping and intervention analysis, RadVision3D. The Reactor Water Cleanup valve is an Anchor Darling valve that needed to be breached and have the internals replaced during a refuel outage. It is located in a […]